Kristoff Costume Tutorial

I started by folding my material and laying a shirt down for a pattern. I wanted it to be bulkier than the shirt I used. You could cut out two pieces, but I choose to skip the step to sew the top by making my fold there. Next I cut a V where the neck would go. (See picture) I turned the material inside out with right sides together. I pinned where I would stop sewing for the sleeves. I love using my quilting ruler for this. Sew up the sides.

With the shirt still inside out I cut two small rectangles on a fold for my sleeves. Sew the seam for each sleeve. Then pulling the sleeve out so it’s the “right” way, tucked it into your shirt. (See picture) Sew, matching your seam. It doesn’t have to be perfect because he probably got it from the trolls.

Then I cut a long rectangle 4″ long strip for my collar. (See picture) Next I arranged it on my shirt. Starting at the arrow I stitched across the two pieces with my “collar” piece in the front. This helped it stay upright. Make sure to stop where the collar ends on the back section. Then you can stitch your two ends of your collar to the front part of the shirt. I kept the collar on top of the shirt.

Now we can apply our trim. I was really excited about this trim I found at JoAnne’s. I think it matches pretty well. Starting at the left part of the collar I laid my trim out and stitched down the V of the neck. Leave a tail. (See picture) Then I went back to the starting point and zig zagged across the trim so it wouldn’t fray. Then I put another piece on that and zig zagged that on top. Then I followed with a basic stitch to the other side of the V, going around the neck. Again I left a tail, this one slightly longer. Bending the trim and tucking in a corner to make the design go straight down, pin it to stay in place. Do this for both sides of loose trim. With my trim I stitched it down following the design and stitching next to the border. Once I did one of the loose ends I clip the other loose end to match exactly. When finished with both lines make sure to zig zag the bottom of the trim. I added another line of trim across the shoulders. Then I did my basic stitch on the other side of the border for the whole garment.

Now it’s time to work with the fur. It wasn’t too bad. After each cut I went through and removed extra hair then so it wouldn’t get all over as I was sewing. It still did, kinda. But it was manageable. I cut long rectangles, the whole width of my material. Then with my shirt facing right side up I laid the fur facing down on top of the shirt. I stitch along the bottom. I then folded it down when I was done. Do the same thing with the sleeves.

For his hat I used a beanie as a pattern. Cut two pieces and sew right sides together. My 4 year old told me I needed a ball on top. I grabbed a rectangle scrap and with my rotary cutter and ruler I sliced tiny strips. (See below) Then using thread wrap it around the middles and double knot it. Fluff up the pieces and sew it on top.